Union Instruments CWD3000 EXP - Fig. 6.9: Transport Securing Devices of Pressure Controller

Transport, installation and acceptance
51
Transport securing device in the pressure controller
Fig. 6.9: Transport securing devices of pressure controller
Transport securing device
Order of removal/attachment of
transport securing device
Transport securing device of pressure
controller
•
Remove the retaining belts.
• Open the protective flap (screw
closure).
• Remove the transport securing device
(bubble wrap).
• Reclose the protective flap.
Proceed in reverse order to reattach the transport securing device.
Transport securing device of density measuring cell
Transport securing device
Order of removal/attachment of
transport securing device
Transport securing device of density
measuring cell
• Remove the white cable ties around
the density measuring cell.
• Loosen the screw.
• Density measuring cell must swing
freely.
Proceed in reverse order to reattach the transport securing device.
Observe the length of the screw!