Operation
Main menu - Options - Calibration - Automatic calibration 2
The automatic calibration that is defined by a situation is configured in this menu.
Criterion 1:
Automatic calibration after restart.
Criterion 2:
Automatic calibration at a defined change in ambient temperature compared to the
last calibration.
Main menu - Options - Calibration - Calibration
The calibration is started with this key.
This stops the automatic calibrations.
Main menu - Options - Calibration - Save base calibration
The measured values are saved with this key. These values are reference values
for additional calculations during the next calibration. Any deviations from these
reference values are stored in the event list.
To Next Page
Loading...