CONTENTS
6．WEIGHING MODE SETTING AND OPERATION ................59
6-1．Feed Weighing and Discharge Weighing ......................................... 60
6-1-1 Feed Weighing ................................................................................. 60
6-1-2 Discharge Weighing ........................................................................ 63
6-1-3 Weighing Mode ................................................................................ 66
6-2．Simple Comparison Control and Sequence Control ....................... 67
6-2-1 Simple Comparison Control ........................................................... 67
6-2-2 Sequence Control ............................................................................ 69
6-2-3 Mode Selection ................................................................................. 74
6-3．FF CPS. Regulation Value / Free Fall Compensation /
Avg. Count of FF CPS. / FF CPS. Coefficient ................................... 75
6-4．Final / Set Point 2 / Set Point 1 / FF CPS. / Over / Under ................. 78
6-5．Near Zero / Upper Limit / Lower Limit ............................................... 79
6-6．U/L Limit Comparison / U/L Limit Comparison Mode/
Near zero Comparison / Over/Under Comparison /
Over/Under Comparison Mode ......................................................... 80
6-7．Complete Signal Output Mode / Complete Output Time /
Compare Time / Comparison Inhibit Time ....................................... 82
6-8．Judging Times / AZ Times / At Start NZ Confirmation /
At Start WV Confirmation /Auto Jog (ON/OFF) / Auto Jog Timer .. 83
6-9．Net Weight Over / Gross Weight Over .............................................. 87
7．LADDER DIAGRAM .............................................................88
8．SETTING VALUES LIST .......................................................95
9．ERROR CODE ......................................................................97
9-1．Error Code and Error Assistance Code ............................................ 97
9-2．Error Description ................................................................................ 98
9-2-1 Calibration Error .............................................................................. 98
9-2-2 Weight Error ................................................................................... 102
9-2-3 Sequence Error .............................................................................. 104
10．BLOCK DIAGRAM ............................................................106
To Next Page