Unitech MS832 - Chapter 8; Utilities; To Add a Test Code I.D. Prefix to All Symbologies; Show Decoder Revision

102
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Chapter 8
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the decoded symbology.
(See the Symbology Chart, beginning on page 112) for the single character code that identifies
each symbology.) This action first clears all current prefixes, then programs a Code I.D. prefix
for all symbologies. This is a temporary setting that will be removed when the unit is power
cycled.
Show Decoder Revision
Scan the bar code below to output the decoder revision.
Show Scan Driver Revision
Scan the bar code below to output the scan driver revision. The scan driver controls image
capture.
Show Software Revision
Scan the bar code below to output the current software revision, unit serial number, and other
product information.