Unitech MS832 - Miscellaneous Commands

45
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Search backward for a character
F9 Search the input message backward for “xx” character from the current cursor position,
leaving the cursor pointing to the “xx” character.
Syntax = F9xx where xx stands for the search character’s hex value for its ASCII code.
Refer to the ASCII Conversion Chart (Code Page 1252), beginning on page 115 for
decimal, hex and character codes.
Search forward for a non-matching character
E6 Search the input message forward for the first non-“xx” character from the current cursor
position, leaving the cursor pointing to the non-“xx” character. Syntax = E6xx where xx
stands for the search character’s hex value for its ASCII code.
Refer to the ASCII Conversion Chart (Code Page 1252), beginning on page 115 for
decimal, hex and character codes.
Search backward for a non-matching character
E7 Search the input message backward for the first non-“xx” character from the current cursor
position, leaving the cursor pointing to the non-“xx” character. Syntax = E7xx where xx
stands for the search character’s hex value for its ASCII code.
Refer to the ASCII Conversion Chart (Code Page 1252), beginning on page 115 for
decimal, hex and character codes.
Miscellaneous Commands
Suppress characters
FB Suppress all occurrences of up to 15 different characters, starting at the current cursor
position, as the cursor is advanced by other commands.
When the FC command is encountered, the suppress function is terminated. The cursor is
not moved by the FB command.
Syntax = FBnnxxyy . .zz where nn is a count of the number of suppressed characters in
the list, and xxyy .. zz is the list of characters to be suppressed.
Stop suppressing characters
FC Disables suppress filter and clear all suppressed characters. Syntax = FC.
Replace characters
E4 Replaces up to 15 characters in the output message, without moving the cursor.
Replacement continues until the E5 command is encountered. Syntax =
E4nnxx
1
xx
2
yy
1
yy
2
...zz
1
zz
2
where nn is the total count of of the number of characters in the
list (characters to be replaced plus replacement characters); xx
1
defines characters to be
replaced and xx
2
defines replacement characters, continuing through zz
1
and zz
2
.