80
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
When Check Character is set to Validate Type 10/11, but Don’t Transmit, the unit will only read
MSI bar codes printed with the specified type check character(s), but will not transmit the check
character(s) with the scanned data.
MSI Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 49) for additional information. Minimum and Maximum lengths = 4-48.
Minimum Default = 4, Maximum Default = 48.
To Next Page
Loading...
