31
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Scan Centering On, then scan one of the following bar codes to change the top, bottom, left,
or right of the centering window. Then scan the percent you want to shift the centering window
using digits on the inside back cover of this manual. Scan Save. Default Centering = 40% for
Top and Left, 60% for Bottom and Right.
No Read
With No Read turned On, the scanner notifies you if a code cannot be read.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” you can edit the
output message (see Data Formatting beginning on page 40).
The hex code for the No Read symbol is 9C.
To Next Page
Loading...
