Unitech MS832 - Good Read Delay; User-Specified Good Read Delay; Manual Trigger Mode

24
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Good Read Delay
This sets the minimum amount of time before the scanner can read another bar code. Default
= 0 ms (No Delay).
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below, then set
the delay (from 0-30,000 milliseconds) by scanning digits from the inside back cover, then
scanning Save.
Manual Trigger Mode
When in manual trigger mode, the scanner scans until a bar code is read, or until the button is
released. Default = Manual Trigger-Normal.