50
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Codabar
<Default All Codabar Settings>
Codabar On/Off
Codabar Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the bar code.
You may either transmit, or not transmit Start/Stop characters.
Default = Don’t Transmit.
Codabar Check Character
Codabar check characters are created using different “modulos.” You can program the scanner
to read only Codabar bar codes with Modulo 16 check characters. Default = No Check
Character.
No Check Character indicates that the scanner reads and transmits bar code data with or
without a check character.
When Check Character is set to Validate and Transmit, the scanner will only read Codabar
bar codes printed with a check character, and will transmit this character at the end of the
scanned data.
To Next Page
Loading...
