88
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
GS1 Composite Code Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 49) for additional information. Minimum and Maximum lengths = 1-2435.
Minimum Default = 1, Maximum Default = 2435.
GS1 Emulation
The scanner can automatically format the output from any GS1 data carrier to emulate what
would be encoded in an equivalent GS1-128 or GS1 DataBar symbol. GS1 data carriers
include UPC-A and UPC-E, EAN-13 and EAN-8, ITF-14, GS1-128, and GS1-128 DataBar and
GS1 Composites. (Any application that accepts GS1 data can be simplified since it only needs
to recognize one data carrier type.)
If GS1-128 Emulation is scanned, all retail codes (U.P.C., UPC-E, EAN8, EAN13) are
expanded out to 16 digits. If the AIM ID is enabled, the value will be the GS1-128 AIM ID, ]C1
(see Symbology Chart on page 112).
If GS1 DataBar Emulation is scanned, all retail codes (U.P.C., UPC-E, EAN8, EAN13) are
expanded out to 16 digits. If the AIM ID is enabled, the value will be the GS1-DataBar AIM
ID, ]em (see Symbology Chart on page 112).
If GS1 Code Expansion Off is scanned, retail code expansion is disabled, and UPC-E
expansion is controlled by the UPC-E0 Expand (page 72) setting. If the AIM ID is enabled, the
value will be the GS1-128 AIM ID, ]C1 (see Symbology Chart on page 112).
If EAN8 to EAN13 Conversion is scanned, all EAN8 bar codes are converted to EAN13
format.
To Next Page
Loading...
Need help?
General
