53
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Code 39
< Default All Code 39 Settings >
Code 39 On/Off
Code 39 Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the bar code. You may either
transmit, or not transmit Start/Stop characters. Default = Don’t Transmit.
Code 39 Check Character
No Check Character indicates that the scanner reads and transmits bar code data with or
without a check character.
When Check Character is set to Validate, but Don’t Transmit, the unit only reads Code 39 bar
codes printed with a check character, but will not transmit the check character with the scanned
data.
To Next Page
Loading...
