109
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
‧ You need to program a suffix. Programming a suffix enables the scanner to output the bar
code data plus the key you need (such as “CR”) to enter the data into your application.
Refer to Prefix/Suffix Overview beginning on page 34 for further information.
Does the scanner read the bar code incorrectly?
If the scanner reads a bar code, but the data is not displayed correctly on the host screen:
‧ The scanner may not be programmed for the appropriate terminal interface.
For example, you scan “12345” and the host displays “@es%.”
Reprogram the scanner with the correct Plug and Play bar code. See Programming the
Interface beginning on page 6.
‧ The scanner may not be programmed to output your bar code data properly.
For example, you scan “12345” and the host displays “A12345B.”
Reprogram the scanner with the proper symbology selections. See Chapter 6.
The scanner won’t read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the scanner reads the sample bar
codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see Chapter 6).
If the scanner still can’t read the sample bar codes, scan All Symbologies (page 49).
If you aren’t sure what programming options have been set in the scanner, or if you want the
factory default settings restored, refer to Resetting the Factory Defaults on page 5.
To Next Page
Loading...
Need help?
General
