59
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
When Check Digit is set to Validate and Transmit, the scanner only reads NEC 2 of 5 bar
codes printed with a check digit, and will transmit this digit at the end of the scanned data.
Default = No Check Digit.
NEC 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 49) for additional information. Minimum and Maximum lengths = 2-80.
Minimum Default = 4, Maximum Default = 80.
To Next Page
Loading...
