69
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the
scanned data, but the unit can be programmed so it will not transmit it. Default = On.
UPC-A Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-A data.
Default = Off for both 2 Digit and 5 Digit Addenda.
UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A bar codes that have addenda.
You must then turn on a 2 or 5 digit addenda listed on page 69. Default = Not Required.
To Next Page
Loading...
