5.3.1.8.2 All day
You can also enable recording for the entire selected day.
To enable, select the respective check box using “◄►” and press “ENTER” or “EDIT”.
Symbol “” indicates that the whole day recording option is enabled; symbol “×” indicates that it is not.
Check the “All day” option to define the recording mode.
The following recording modes can be selected:
all time
mot det
alarm
mot / alm
mot & alm
command
All time
In this mode, recording is continuous for 24 hours.
eIMPORTANT NOTE
If “All time” is selected, in the event of a blackout or if the device is switched off, the device will automatically resume
recording as soon as network voltage is resumed and the device is switched on again.
Motion
In this mode, recording starts as soon as motion is detected.
Alarm
In this mode, recording starts as soon as a sensor detects an alarm.
Motion / alarm
In this mode, recording starts as soon as either a sensor detects an alarm or a motion is detected.
Motion & alarm
In this mode, recording starts as soon as either a sensor detects an alarm and a motion is detected.
Command
In this mode, recording starts when the “REC” button is pressed.
Press “REC” to stop the recording again.
5.3.1.9 Copy to camera
Select “Copy to camera” to select on which cameras to copy the following settings:
• resolution
• bit rate
• frame rate
• enable rec - schedule
Select “all” to copy the settings on all cameras. Select “Copy” and press “ENTER” to copy the settings. Confirmation of
the operation will be required: press “ENTER” again to confirm.
DS1093-005C 44
To Next Page
Loading...
Need help?
General
