Select camera
This option is used to select the cameras to be combined to the selected alarm input. Use “▲▼” to select.
Enable preset
To activate, select the respective check box using “◄►” and press “ENTER” or “EDIT”.
Symbol “” indicates that the Enable preset” option is selected; symbol “×” indicates that it is not.
Refer to chapter 5.6.2.2 for presetting (recalling a preset position).
Preset
This option can be used to enter a preset number to be run.
Enable pattern
Function currently not available.
eIMPORTANT NOTE
On Urmet 1092/650 devices, pattern tours can be started using specific preset buttons (refer to the product manual for
more details).
Enable patrol
Function currently not available.
eIMPORTANT NOTE
On Urmet 1092/650 devices, patrol tours can be started using specific preset buttons (refer to the product manual for
more details).
5.5.1.4 Copy to input
Select “Copy to input” to select on which inputs to copy the following settings:
• Alarm type - handling
Select “All” to copy the settings on all cameras. Select “Copy” and press “ENTER” to copy the settings. Confirmation of
the operation will be required: press “ENTER” again to confirm.
eIMPORTANT NOTE
The “Copy to input” function has no effect on the parameters set in the “Exceptions” menu.
5.5.1.5 Alarm out
Use this option to select the alarm output to be configured.
Use “▲▼” to select.
5.5.1.6 Time
This option is used to set the alarm activation time on the selected output.
Possible options are: “5s”, “10”, “30s”, “1Min”, “2Min”, “5Min”, ”10Min” and ”Manual”.
Use “▲▼” to select.
Select “Manual” option, the alarm output will not be deactivated until “Alarms stop” is pressed in the “
Alarms” menu.
DS1093-005C 54
To Next Page
Loading...
Need help?
General
