Password
This option is used to enter the password for connection operation.
Refer to chapter 5.2.9.1 and 5.2.9.2 for entering characters.
The password may consist of up to 12 characters.
The entered numbers will be replaced by a “*” symbol on the screen for privacy.
Verify
This option is used to enter the password again for PPPoE authentication.
Refer to chapter 5.2.9.1 and 5.2.9.2 for entering characters.
The entered numbers will be replaced by a “*” symbol on the screen for privacy.
Telephone
This option is used to enter the telephone number of the remote PC.
Refer to chapter 5.2.9.1 and 5.2.9.2 for entering characters.
Callback
This option is used to enable the calling number call-back function.
To enable, select the respective check box using “◄►” and press “ENTER” or “EDIT”.
Symbol “” indicates that the selected option is enabled; symbol “×” indicates that it is not.
Data encryption
This option is used to enable the data encryption function.
To enable, select the respective check box using “◄►” and press “ENTER” or “EDIT”.
Symbol “” indicates that the selected option is enabled; symbol “×” indicates that it is not.
5.9.2 RESTORE DEFAULT
This option is used to restore the default parameters of the device. The IP address, gateway and port number used for
video feed transmission will not be restored.
5.9.3 UPGRADE
This option is used to upgrade the firmware.
This operation may be performed from the “FTP” site or using a “USB key”.
The device will need to be rebooted after firmware upgrading.
Periodically check the URMET Domus SpA Customer Service Technical Area for firmware upgrades.
eIMPORTANT NOTE
Some types of USB drives may not be fully compatible with the device.
5.9.4 HARD DISK
This option can be used to format the hard disks.
The following screen will appear.
Figure 51: formatting the hard disk
Use “▲▼” to select the hard disk to be formatted, shift the “Active Frame” to “Format”, and press “Enter”.
DS1093-005C 72
To Next Page
Loading...
Need help?
General
