5.4.2.3 IP Event Server
This option can be used to set the Event server IP address.
Press “EDIT” and use number keys 0-9 to enter the address. Use “◄►” to shift the cursor. Press “ENTER” to confirm or
“ESC” to cancel.
Alarm notifications or warnings set in the “EXCEPTIONS” menu will be sent to this IP address.
5.4.2.4 Port
This option can be used to set the port number used for transmitting the Event Server IP. Press “EDIT” and use number
keys 0-9 to enter the port number. Use “◄►” to shift the cursor. Press “ENTER” to confirm or “ESC” to cancel.
5.4.2.5 NAS IP
Function currently not available.
5.4.2.6 Dir
Function currently not available.
5.4.2.7 Web port
This option can be used to set the port number used for the Internet Explorer browser. The default setting is 80.
Press “EDIT” and use number keys 0-9 to enter the port number. Use “◄►” to shift the cursor. Press “ENTER” to
confirm or “ESC” to cancel.
5.4.2.8 PPPoe
This option is used to enable PPPoE dial- up functions.
To enable, select the respective check box using “◄►” and press “ENTER” or “EDIT”.
Symbol “” indicates that the PPPoE function is enabled; symbol “×” indicates that it is not.
The following can be defined after enabling the “PPoE” option:
user
password
verify
User
This option is used to enter the user name for PPPoE authentication.
Refer to chapter 5.1.2.1 for entering characters.
The user name may consist of up to 32 characters.
Password
This option is used to enter the password for PPPoE authentication.
Refer to chapter 5.1.2.1 for entering characters.
The password may consist of up to 14 characters.
Verify
This option is used to enter the password again for PPPoE authentication.
Refer to chapter 5.1.2.1 for entering characters.
DS1093-005C 50
To Next Page
Loading...
Need help?
General
