USR IOT USR-DR404 - At+Wskey

USR-DR404 user manual www.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
63
+ok<CR>< LF ><CR>< LF >
Parameters:
 mode: WIFI mode, including
 AP: Wireless access point mode
 STA: Wireless terminal mode
After restarting the module, parameters take effect.
4.3.4.10. AT+WSKEY
Function: Query/Set encryption parameters in STA mode.
Format:
Query : AT+WSKEY<CR>
+ok=<auth,encry,key><CR>< LF ><CR>< LF >
Setting: AT+ WSKEY=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
 auth: Authentication mode, including
 OPEN
 SHARED
 WPAPSK
 WPA2PSK
 encry: Encryption algorithm, including
 NONE: valid when auth=OPEN.
 WEP-H: valid when auth=OPEN or SHARED（WEP, HEX）
 WEP-A: valid when auth=OPEN or SHARED（WEP, ASCII）
 TKIP: valid when auth= WPAPSK/WPA2PSK
 AES: valid when auth= WPAPSK/WPA2PSK
 key: password, when encry=WEP-H, password is hexadecimal, 10 or 26 digits; when encry=WEP-A, password is ASCII, 5
or 13 digits; when WPA-PSK and WPA2-PSK, password is ASCII, 8~63digits.
This parameter only valid in STA mode, after restarting the module, parameters take effect. But can also be set in AP
mode.