USR IOT USR-DR404 - At+Mslp; At+Wscan

USR-DR404 user manual www.usriot.com
Jinan USR IOT Technology Limited www.usriot.com
66
 WPAPSK
 WPA2PSK
 encry: Encryption algorithm, including
 NONE: valid when auth=OPEN
 WEP-H: valid when auth=OPEN or SHARED（WEP, HEX）
 WEP-A: valid when auth=OPEN or SHARED（WEP, ASCII）
 TKIP: valid when auth= WPAPSK/WPA2PSK.
 AES: valid when auth= WPAPSK/WPA2PSK
 TKIPAES: valid when auth= WPAPSK/WPA2PSK
 key: password, when encry=WEP-H, password is hexadecimal, 10 or 26 digits; when encry=WEP-A, password is ASCII, 5
or 13 digits; when WPA-PSK and WPA2-PSK, password is ASCII, 8~63digits.
This parameter only valid in AP mode, after restarting the module, parameters take effect. But can also be set in STA
mode.
4.3.4.16. AT+MSLP
Function: Module enters sleep mode (whether the module works in AP or STA mode, WIFI is not available at this time)
Format:
Query : AT+ MSLP <CR>
+ok=<sta.><CR>< LF ><CR>< LF >
Setting: AT+ MSLP=<on/off><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
 Query: sta: Returns whether the module sleeps, such as:
 on, Indicates no sleep
 off, sleep
 Setting: off: module enters sleep mode,
on: module exits sleep mode
When the module enters the sleep mode, enter AT + MSLP = on again, module exits the sleep mode. The mode is still
command mode.
4.3.4.17. AT+WSCAN
Function: Search around AP
Format: