Utax P-C2665 MFP User Manual

Preparation before Use
2-18
Use the procedure below to setup the TCP/IP (IPv4) setting.
1 Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in.
NOTE: Refer to Character Entry Method on
Appendix-9 for details on entering characters.
2 In the Sys. Menu/Count. menu, press the  or 
key to select [System/Network], and then press the
OK key.
IMPORTANT: To make the settings, you must have
logged in using a Login User Name with administrator
privileges.
The default settings of the Login User Name and Login
Password are both "2600".
If you have logged in using a Login User Name without
administrator privileges, the screen will display
Administrator only. and return to the standby screen.
3 In the System menu, press the  or  key to
select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the  or  key to select [TCP/IP Settings].
Login User Name: L b
********************
Login Password:
[ Login ]
Sys. Menu/Count.: a b
*********************
2 Counter
3 System/Network
[ Exit ]
1 Report
Administrator only.
System/Network: a b
*********************
2 Optional Network
3 NW InterfaceSend
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 WSD-SCAN
3 WSD-PRINT
[ Exit ]
1 TCP/IP Settings

Utax P-C2665 MFP Specifications

General

Brand	Utax
Model	P-C2665 MFP
Category	All in One Printer
Language	English