V2 AZIMUT User Manual

ENGLISH
- 24 -
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
Press the - key until the
display shows I
Press and hold key
Press and hold key
Press and hold the key
for 5 seconds: I flashes
The dot appears on the
display after approx. 1
second
The dot appears on the
display after approx. 1
second
Release the key: the
segments of the display
illuminate one at a time
until showing 0
Release the key and press the remote control button
twice: the device emits a BEEP and the dot is turned off
to confirm memorising has been successful
Hold the key until the
display is turned off : the
remote controls have been
deleted.
9.8 - END PROGRAMMING
To exit the programming and store the settings of the different parameters, it is necessary to follow this procedure:
10 - MEMORISING RADIO TRANSMITTERS
The device can memorise up to 15 radio transmitters. Proceed as follows:
11 - DELETING RADIO TRANSMITTERS
12 - DISPLAY MESSAGES
Display Reason
L The display shows the letter L when the actuator is working normally and the red cam positioned on the chain activates
the micro switch on the motor
F The display shows the letter F when the door encounters an obstacle
H The display shows the letter H when the encoder or the control unit is malfunctioning
A The display shows the letter A when the photocell intervenes

V2 AZIMUT Specifications

General

Brand	V2
Model	AZIMUT
Category	Controller
Language	English