ENGLISH
AUTOMATION RESTARTING
T
o restart the automation use proceed as follows:
• Bring the C1 unblocking lever back to the initial position.
• Activate the motor with a START input: the slider will hook
automatically the draft truck, restarting the automation.
PLACEMENT AND FASTENING OF THE
MECHANIC STOPS
WARNING: the correct placement and fastening of
the mechanic stops is important for the correct working of
the automation, therefore follow carefully these
instructions.
1. Release the automation and fully open the door.
2. Position the mechanic stop S near the maximum opening
p
oint of the door, then fasten tightly the two grub screws G1.
WARNING: Working normally, the door will stop at about 30
mm from the mechanic opening stop.
3. Completely close the door and position the mechanic closing
stop T at 1 cm from the draft truck C, then fasten tightly the
two grub screws G1.
29
RELEASE FROM OUTSIDE
I
nstall the special accessory release kit to release the
automation from outside (cod. J5).
• Insert the metallic string into the special draft truck hole.
•
Insert the sheath on the string and assemble the rest of
kit parts.
• Stretch the string and fasten it by means of the special
fastening screw so that the complete automation release is
e
nabled.
Once this kit has been installed, just turn the doorknob to
release the automation; turn the doorknob into the beginning
p
osition before open the door
.
WARNING:
• Install the release handle not over 1,8m from the ground
• Use carefully the manual release system: if the gate is
unbalanced it may fall down
To Next Page
Loading...
