Vacon optea - New Features - OPTEA; New Features - OPTE9

General information vacon • 11
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
2
2.1 New features - OPTEA
The following table shows the new features that are added in the OPTEA Advanced Dual Port
Ethernet's firmware version.
Table 4. New features - OPTEA
PROFISAFE is supported in NXP only when OPTBL/M/N is also installed.
2.2 New features - OPTE9
The following table shows the new features that are added in the OPTE9 Dual Port Ethernet's
firmware versions.
New feature Firmware version
PROFINET IO + PROFIsafe V001
Support for all features supported by OPTE9 board
including EtherNet/IP and Modbus TCP/UDP protocols
V002
Improved emulation mode with OPTCP, OPTCQ and
OPTCI boards when installed to VACON
®
NXP
V002
PROFINET IO System Redundancy "S2" V002
Table 5. New features - OPTE9
New feature Firmware version
EtherNet/IP protocol V004
Ethernet ring support (RSTP) V004
Address Conflict Detection (ACD) V004
Media Redundancy Protocol (MRP) V006
Simple Network Management Protocol (SNMP) V006
LLDP-MIB, LLDP-EXT-DOT3-MIB, LLDP-EXT-PNO-MIB V006
EDD files SIMATIC PDM V006
Fast communication modes in VACON
®
NXP
V007
PROFINET IO Alarms V007
Simple Network Time Protocol (SNTP) V008
Fast MRP support verified V008
Device Level Ring (DLR) V009