Vacon optea - VACON OPTE9 Dual Port Ethernet Drive Support

5
vacon • 28 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5.2 VACON
®
OPTE9 Dual Port Ethernet drive support
The VACON
®
OPTE9 Dual Port Ethernet option board can be used with the following VACON
®
AC
drives.
VACON
®
100 family support
The VACON
®
100 family AC drives are supported from the OPTE9 firmware version V003. The
process data in VACON
®
100 family AC drives is 32 bit. The 32-bit process data support is planned
for later firmware release. Only 16-bit process data is supported.
EtherNet/IP support
EtherNet/IP protocol was added to OPTE9 firmware version V004. The table below shows required
minimum AC drive firmware version .
Table 12. OPTE9 supported AC drives and slots
AC drive Slots
From AC drive SW
version on
From OPTE9 SW
version on
VACON
®
NXP
D, E NXP00002V188 V001
VACON
®
NXS
D, E NXS00002V179 V001
VACON
®
100 INDUSTRIAL
and 100 X
D, E FW0072V018 V003
VACON
®
100 FLOW
D, E FW0159V012 V003
VACON
®
20
- FW0107V011 V002
VACON
®
20 X and CP
- FW0117V007 V002
Table 13. Required minimum AC drive firmware versions
AC Drive From AC drive SW version on
VACON
®
NXP
NXP00002V191
VACON
®
NXS
NXS00002V181
VACON
®
100 INDUSTRIAL and
100 X
FW0072V018
VACON
®
100 FLOW
FW0159V012
VACON
®
20
FW0107V012
VACON
®
20 X and CP
FW0117V009