Vacon optea - PC Tools for VACON 100 Family and VACON 20; VACON Live

5
vacon • 54 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Figure 29. NC Drive: OPTEA parameters
NOTE! The NCDrive software can be used with the Ethernet board in VACON
®
NXS and NXP drives.
NOTE! The NCDrive software is recommended to be used in LAN (Local Area Network) only.
NOTE! This feature does not work with VACON
®
100 family AC drives.
5.8.5 PC Tools for VACON
®
100 family and VACON
®
20 / VACON
®
Live
VACON
®
Live can be used to configure all the settings of the OPTE9 option board. VACON
®
Live can
be downloaded from http://drives.danfoss.com website.
To configure the IP settings of the OPTEA or OPTE9 option board, follow the steps below:
NOTE! VACON
®
20, VACON
®
20 X and VACON
®
20 Cold Plate do not support VACON
®
Live
connection over the OPTE9 Ethernet port. OPTEA does not support VACON 20
®
, VACON
®
20 X and
VACON
®
20 CP drives.
Step 1. Connect your PC to the Ethernet network with an Ethernet cable. You can also connect the
PC directly to the drive using a crossover cable. This option may be needed if your PC does not
support Automatic crossover function.
You can also connect to the VACON
®
100 family AC drive by its serial port. In any case the steps
below are the same for both connections.
NOTE! You cannot use VACON
®
Live via the option board if the option board does not have a valid IP
address. If you change the IP settings of the option board when connected through it, VACON
®
Live
connection will be lost.