Vacon optea - Updating the OPTEA and OPTE9 Option Board Firmware with VACON Loader

5
vacon • 46 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5.8.2 Updating the OPTEA and OPTE9 option board firmware with VACON
®
Loader
The VACON
®
Loader can be downloaded from http://drives.danfoss.com website. It has been
bundled with the VACON
®
Live software package.
To update the option board firmware, follow the steps below.
NOTE! With VACON
®
20, the baud rate 9600 must be used. With VACON
®
20 X and VACON
®
20 CP,
the following baud rates are supported: 9600, 19200, 38400 or 57600.
Step 1. Connect your PC to the controller by using the USB/RS485 cable.
Then select the firmware file which you want to load to the option board and double click it. This will
start the VACON
®
Loader software. You can also start the program from the Windows Start menu.
In this case, select the firmware file using the "Browse" button (see Figure 16).
Figure 16. VACON
®
Loader: File selection