Layout and connections vacon • 13
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
4
4. LAYOUT AND CONNECTIONS
The VACON
®
Ethernet option boards are connected to the Ethernet bus using the standard RJ45
connectors (1 and 2). The communication between the control board and the AC drive takes place
through a standard VACON
®
Interface Board Connector. OPTEA and OPTE9 boards have identical
layout and connections.
4.1 Layout and connections
Figure 1. Option board layout
A Ethernet connector C Interface Board connector
B Ethernet connector
Table 7. Ethernet ports
Ethernet port Description
1 Ethernet port 1 (PHY1)
2 Ethernet port 2 (PHY2)
To Next Page
Loading...
