Installation vacon • 55
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5
Step 2. Start VACON
®
Live. When the program starts and it asks "Select startup mode", select
"Online". The program will scan your network for compatible drives. When found, they will be added
to the list. Select the drive that the option board is connected to and press "Connect to select".
Figure 30. VACON
®
Live: The ”Startup mode” dialogue box
Figure 31. VACON
®
Live: The “Select devices” dialogue box
NOTE! The first column is the drive's name, but the information about IP and MAC addresses come
from the option board (if the device on the list is an option board).
NOTE! Some switches block broadcast messages. In this case, each network node must be scanned
separately.
To Next Page
Loading...
