USER'S GUIDE____________________________________________________________________
38 __________________________________________________________________ M210619EN-D
Output formatting
FORM Serial output format
TIME Set time
DATE Set date
FTIME [ON/OFF] Add time to SEND and R outputs
FDATE [ON/OFF] Add date to SEND and R outputs
UNIT Select metric or nonmetric output
units
FST [ON/OFF] Output state of optional probe
heating and chemical purge (with
SEND and R commands)
Other commands
? Check transmitter settings
?? Check transmitter settings in
POLL-mode
ECHO [ON/OFF] Serial bus echo
FIND All devices in POLL-mode send
their addresses
HELP List commands
PRES Set ambient pressure for
calculations (non-volatile)
XPRES Set ambient pressure for
calculations
FILT Set result filtering
RESET Reset transmitter
ERRS Display error messages
Setting, scaling and testing analog outputs
AMODE Set analog outputs (0/4 ... 20 mA)
ASEL Select parameter for analog outputs
ASCL Scale analog outputs
ITEST Test analog outputs
AQTEST Test analog outputs for desired
readings
AERR Set error outputs
Calibration and adjustment (these are presented in Chapter 7, section
Calibration and Adjustment Commands on page 67)
CRH Relative humidity calibration
CT Temperature calibration
LI Revert factory calibration
FCRH Relative humidity calibration after
sensor change
CTEXT Set calibration information text
CDATE Set calibration date
ACAL Analog output calibration
To Next Page
Loading...
