Vaisala HUMICAP HMT310 - FTIME, FDATE Add Time and Date to SEND and R Outputs; UNIT Select Metric or Nonmetric Output Units

Chapter 4 ________________________________________________________________ Operation
VAISALA_______________________________________________________________________ 45
Sets the time and date to the transmitter.
Example:
>time<cr>
Current time is 04:12:39
Enter new time (hh:mm:ss) ? 12:24:00<cr>
>date<cr>
Current date is 2000-01-01
Enter new date (yyyy-mm-dd) ? 2004-06-30<cr>
>
NOTE
Time and date are cleared to 2000-01-01 00:00:00 at reset.
NOTE
Only about 1 % accuracy is obtained with the software clock.
FTIME, FDATE Add Time and Date to
SEND and R Outputs
Syntax: FTIME x<cr>
Syntax: FDATE x<cr>
Where
x = ON/OFF
The command enables or disables output of time and date to the serial
line.
UNIT Select Metric or Nonmetric Output
Units
Syntax: UNIT x<cr>
Where
x = M or N
M = metric units
N = nonmetric units