Vaisala HUMICAP HMT310 - SERI Serial Line Settings; ADDR Set Transmitter Address for Use in POLL-Mode

Chapter 4 ________________________________________________________________ Operation
VAISALA_______________________________________________________________________ 41
Example:
>smode run<cr>
Output mode : RUN
>smode stop<cr>
Output mode : STOP
SERI Serial Line Settings
Syntax: SERI b p d s<cr>
Where
b = bauds (300, 600, 1200, 2400, 4800, 9600,19200)
p = parity (n = none, e = even, o = odd)
d = data bits (7 or 8)
s = stop bits (1 or 2)
The settings can be changed one parameter at a time or all parameters at
once:
Example:
>seri o<cr> changing parity only
4800 o 7 1
>seri 600 n 8 1<cr>
changing all parameters
600 n 8 1
ADDR Set Transmitter Address for Use in
POLL-Mode
Syntax: ADDR aa<cr>
Where
aa = Address (0 ... 99)
Example:
>addr<cr>
Address : 0
>addr 1<cr>
Address : 1