Vaisala HUMICAP HMT310 - Output Formatting; FORM Serial Output Format

Chapter 4 ________________________________________________________________ Operation
VAISALA_______________________________________________________________________ 43
Example:
Relative humidity calibration is performed at transmitter 2, which is in
POLL-mode.
>open 2<cr>
Opens the line to transmitter 2.
>crh<cr>
Calibration started.
...
>close<cr>
Line closed.
Output Formatting
FORM Serial Output Format
Syntax: FORM x<cr>
Where
x = Formatter string
Command format can be used to change the format of the output
commands SEND and R.
Format string consists of quantities and modifiers: use the quantity
abbreviations and modifiers presented in Table 5 on page 44 and in Table
6 on page 44 when selecting the output quantities.