SECTION 6: MAINTENANCE AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 60 090019-OP_r0
24
Inspect welding electrode
clamp and ground clamp
••
Ensure that welding electrode and ground clamps are
in satisfactory for operation (no cracks or advanced
wear). Repair or replace as necessary.
25 Replace the air compressor
and generator drive belts
••
Consult Section 6.5.7 and applicable sub-sections
on how to replace and re-tension the drive belts.
26
Inspect the generators and
the automatic belt tensioner
••
Ensure that the automatic belt tensioner is free of
rough, noisy or worn bearings. Consult Section
6.5.7.8, Replacing and Re-tensioning the Generator
Belt.
27
Inspect compressor head
valves. Clean the carbon from
valves and head if necessary
•
Refer to Sections 6.5.4, Compressor Head Valve
Assembly Inspection and Maintenance for
compressor head valve maintenance procedures.
28
Check and tighten all bolts,
nuts, etc., if necessary
•
Check all bolt and nut fastenings to assure tightness,
and/or correct torque values where applicable. Check
more frequently under heavy use conditions.
29
Check compressor unloader
valve(s) operation
•
Refer to Sections 6.5.3, Unloader Valve
Maintenance, for unloader valve maintenance
procedures.
Consult Section 9.1 and Table 9A for replacement part order numbers.
NOTE: Consult Section 6, Maintenance for additional, non-routine maintenance procedures.
6.3 MAINTENANCE SCHEDULE TABLE
INTERVALS
BREAK-
IN
PERIOD
MAINTENANCE SCHEDULE
Hourly or Calendar Period - whichever
comes first
NOTE
First 20
Hours of
Operation
After 8
Hours or
Daily
After 40
Hours or
Weekly
Every 100
Hours or
One Year
Every 200
Hours
After 600
Hours
After 1000
Hours
If working in dusty or dirty conditions, reduce the
recommended time intervals between servicing by
half for engine and compressor oil change, and
engine and compressor filter servicing.
KEY TASK DESCRIPTION
ACTION TO TAKE
To Next Page
Loading...
