AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090019-OP_r0 PAGE - 59
16
Inspect unit mounting bolts
•••
Tighten any loose mounting bolts as necessary.
17
Blow out the DC welding
generator and AC generator
•••
Use compressed air to clear out generators (NOTE:
carry out every 100 hours if operating in dirty
environmental conditions.)
18
Replace engine fuel filter(s)
••••
Consult Section 6.5.9.4, Replacing the In-line Fuel
Filters.
19
Check compressor cut-in and
cut-out pressures
••
Ensure that the cut-in and cut-out pressure settings are
correct. Adjust if necessary, per Section 6.5.5,
Adjusting Compressor Cut-In/Cut-Out Pressure.
20
Replace engine spark plugs
(Check at 200 hours)
••
Consult the procedure in the Engine Operator’s Manual
on how to change the spark plugs.
21
Replace engine air filter
••••
Consult Section 6.5.9.1, Engine Air Filter
Maintenance, on how to change the air filter.
22
Check the engine speed
••
Ensure that the engine speed is running at correct
interval. Adjust if necessary, per Section 6.5.6,
Adjusting the Engine Speed.
23
Inspect the welding leads and
battery charging cables
••
If so equipped, ensure that welding leads are
satisfactory for operation (no cracks or advanced
wear). Repair or replace as necessary.
6.3 MAINTENANCE SCHEDULE TABLE
INTERVALS
BREAK-
IN
PERIOD
MAINTENANCE SCHEDULE
Hourly or Calendar Period - whichever
comes first
NOTE
First 20
Hours of
Operation
After 8
Hours or
Daily
After 40
Hours or
Weekly
Every 100
Hours or
One Year
Every 200
Hours
After 600
Hours
After 1000
Hours
If working in dusty or dirty conditions, reduce the
recommended time intervals between servicing by
half for engine and compressor oil change, and
engine and compressor filter servicing.
KEY TASK DESCRIPTION
ACTION TO TAKE
Continued on next page
To Next Page
Loading...
