Vatech PaX-i Plus User Manual

1. Introduction
PaX-i Plus / Insight Installation Manual 1
1. Introduction
1.1 Manufacturer's Liability
As the manufacturer, VATECH assumes liability for the safe and reliable installation
and operation of this equipment only when:
 Equipment installation, including software installation, was carried out by an
authorized agent in accordance with this installation manual.
 Electrical installation was carried out in accordance with the appropriate
requirements specified in IEC-60363.
 Genuine original or approved replacement parts are used.
 Maintenance/repair service has been performed by a qualified technician(s) from
one of our authorized agents.
 The equipment has been used under normal condition in accordance with the
user's manual.
 PC Software has been properly used in accordance with the manufacturer’s
installation instructions and user manuals.
1.2 Customer’s Responsibility
Site planning and preparation are the responsibility of the customer. The following
points should be considered fundamentally important to all customers of this product:
 Install all required materials prior to delivery of the system.
 Complete the floor, ceiling and walls of the room before installing the equipment.
 Install proper sized junction boxes, with covers, at the necessary locations.
 Install a mains power with the proper voltage output and an adequate kVA rating.
 Install the circuit breaker specified by this manual.
 Provide the installer(s) with the current dimensions of the room including the hall
way and entry door sizes.
 The customer must have an electrician install more than two power outlets in the
room.

Vatech PaX-i Plus Specifications

General

Brand	Vatech
Model	PaX-i Plus
Category	Dental equipment
Language	English