Veeder-Root VaporTEK - Page 4

Table of Contents
iv
Gas Meter Calibration .....................................................................................................46
Pulse Rate Setup With FB1 Terminal .............................................................................48
Pulse rate setup on VaporTEK Interface ................................................................48
Pulse Rate Setup with FB1.....................................................................................48
Auto-Calibration using FB1 Terminal ..............................................................................49
Simulation with FB1 Terminal .........................................................................................50
VaporTEK Pump Troubleshooting and Quick Help
Troubleshooting and Quick Help ....................................................................................51
Appendix A: VaporTEK System Reference Wiring Diagrams
Figures
Figure 1. VaporTEK System Basic Components ...................................................1
Figure 2. Auxiliary VaporTEK System Components ..............................................2
Figure 3. VaporTEK Pump Dimensions ...............................................................13
Figure 4. VaporTEK-3 Controller Board Connections ..........................................14
Figure 5. VaporTEK-3 Controller Board Connected To The VaporTEK
Pulse Interface Adapter Board ..............................................................15
Figure 6. VaporTEK Pulse Interface Adapter Board Jumper Settings .................15
Figure 7. VaporTEK Valve Adapter Board Connected To The
VaporTEK-3 Controller board ...............................................................17
Figure 8. VaporTEK Pump Installation Orientations ............................................20
Figure 9. Install The VaporTEK-3 Controller Board Mounting Bracket In
The Dispenser’s Electronic Compartment ............................................21
Figure 10. VaporTEK Pulse Interface Adapter Board Mounted To Back Of
VaporTEK-3 Controller Board Housing .................................................22
Figure 11. VaporTEK-3 Controller Board Mounting Cover Secured
With Safety Label Affixed. .....................................................................23
Figure 12. Apply Thermal Transfer Paste To These Component Surfaces ...........24
Figure 13. Apply Thermal Transfer Paste To These Component Surfaces ...........24
Figure 14. Old Versus New Style VaporTEK Cable Plugs .....................................25
Figure 15. VaporTEK System - High Voltage Hook Signal Input ...........................28
Figure 16. VaporTEK System - Liquid Pulse Signal Input .....................................29
Figure 17. VaporTEK System - Liquid Pulse Signal Input And Monitoring ............30
Figure 18. VaporTEK System – Serial Connection And Monitoring Using
RS422 – Interface With Re-regulation Function. ..................................31
Figure 19. VaporTEK System - Low Voltage Hook Signal With Relay Switch .......32
Figure 20. VaporTEK Low Voltage Relay Diagram ................................................32
Figure 21. VaporTEK High Voltage Relay Diagram ...............................................33
Figure 22. VaporTEK USB-Adapter Service ..........................................................34
Figure 23. Calibration Setup ..................................................................................46
Figure 24. Locate the Burkert Gas Meter Calibration Factor .................................47
Figure A-1. VaporTEK Plus For Collection - Encore 500S With
VaporTEK-3 Controller ....................................................................... A-1
Figure A-2. Vaportek System Plus for collection only
W/3 Color LED - Encore 500S Dispenser ........................................... A-2