Veeder-Root VaporTEK - Introduction; Contractor Certification Requirements; Figure 2. Auxiliary Vaportek System Components

Introduction Contractor Certification Requirements
2
Auxiliary Components supported by the VaporTEK System:
• VaporTEK Pulse Interface Adapter Board (Dispenser based Design)
• VaporTEK Valve Adapter Board (for VaporTEK Enhanced Systems)
Figure 2. Auxiliary VaporTEK System Components
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
VEEDER-ROOT
VTEK3-EPV-
ADAPTER
900900-001
A B 0V 5Vout
X2
X1
F1 F3
SIDE B
SIDE A
VTEK3- CTRL
X3
To VaporTEK-3 Controller Board X8
Pulse Interface Port
VaporTEK
Valve Adapter Board
Pulse Inputs
Side A
315mA 315mA
(8 -24) VDC
Power
Pulse Inputs
Side B
PE GND +24V
P3A P2A P1A GND GND P4B GND GND P4A P3B P2B P1B
EPV B
VaporTEK
Pulse Interface
Adapter Board
EPV B
EPV B EPV B
Duncansville,PA.16
Type: EPV10
SIRA 12ATEX6058X -40°
Valve: II 1/2G c T3
Solenoid: II 2G Ex MB
EPV B
EPV A
EPV B