EasyManuals Logo

Vespa LX 50 Workshop Manual

Vespa LX 50
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
- Remove the three guide pins and the mobile half
pulley.
Removing the driven half-pulley bearing
- Remove the roller bearing with the special ex-
tractor inserted from the bottom of the fixed half-
pulley.
CAUTION
POSITION THE HOLDING EDGE OF THE EXTRACTION PLI-
ERS BETWEEN THE END OF THE BEARING AND THE
BUILT IN SEALING RING.
Specific tooling
001467Y029 Bell for bearings, O.D. 38 mm
- Remove the ball bearing retention snap ring.
- Expel the ball bearing from the side of the clutch
housing by means of the special tool.
N.B.
PROPERLY SUPPORT THE HALF-PULLEY SO AS NOT TO
DEFORM THE SLIDING SURFACE OF THE DRIVING BELT
Specific tooling
020376Y Adaptor handle
020363Y 20-mm guide
Inspecting the driven fixed half-pulley
- Check that there are no signs of wear on the work
surface of the belt. If there are, replace the half-
pulley..
- Make sure the bearings do not show signs of un-
usual wear.
- Measure the external diameter of the pulley bush-
ing.
Characteristic
Vespa LX 50 Engine
ENG - 65

Table of Contents

Other manuals for Vespa LX 50

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vespa LX 50 and is the answer not in the manual?

Vespa LX 50 Specifications

General IconGeneral
Engine TypeSingle-cylinder, 4-stroke
Displacement49.9 cc
Fuel SystemCarburetor
Front Brake200 mm disc
Rear Brake110 mm drum
Seat Height785 mm
Fuel Tank Capacity8.6 liters
Tires Front110/70 - 11"
Tires Rear120/70 - 10"
Length1, 770 mm
Width705 mm
Cooling SystemAir cooled
TransmissionAutomatic
Max Power3.2 kW
Max Torque4.2 Nm

Related product manuals