Chapter 4 Configuring the 6000A V2 Platform
Defining the screen parameters of the 6000A V2 Platform
20 User Manual 76100000200 Rev. 001
If Server Name is selected, enter the name of the server, and if
necessary a name for second server. During synchronization, the
first server name will always be used, but if a fail occurs, the second
one will be used.
If Dynamic or Static mode is defined, the current Date and Time cannot
be modified (parameters are greyed) and the icon displays on the
upper banner, between the hour and the date .
– None: the time is not synchronized according to a server. In this
case, the user can reset date and time himslef, using the fields Date
and Time.
Defining the screen parameters of the 6000A V2 Platform
In the System Settings page, the following parameters can be defined:
Backlight
1 Click on Backlight
2 Define the backlight level of the screen, using the left and right
direction keys, or clicking on Edit Number softkey and using the
keypad displayed.
– Min backlight level
: -5
– Max backlight level
: +5
Contrast
1 Click on Contrast
2 Select the type of environment into which the instrument is used:
– Indoor: to be selected when the instrument is used inside (see
Figure 8 on page 18)
– Outdoor: to be selected in order to optimize the readability of
the screen for an outside use.
If the network configuration is modified, synchronization may be
lost.
If the 6000A V2 Platform is operating on battery, it is advisable to
choose a minimum lighting level, acceptable for the user, to keep
endurance as long as possible.
To Next Page
Loading...
