Chapter 6 Scope
Scope feature
36 User Manual 76100000200 Rev. 001
Scope feature
Overview
This feature enables you to verify that your optical connectors are in
perfect shape and very clean condition.
The P5000i Digital Probe Microscope is a portable handheld microscope
used to view and inspect both the bulkhead (female) and patch cord
(male) sides of fiber connectors as well as other optical devices, such as
transceivers.
The P5000i requires an FBPT inspection tip and is connected to the
6000A V2 Platform with a USB 2.0 connector.
Installation of
tips
The Pass/Fail analysis function on the 6000A V2 Platform can only be
used with certain inspection tips mounted on the P5000i.
Seven tips, patchcords and bulkheads types, are delivered with the
Videoscope Kit (EDFSCOPE5KI) but many others can be used.
Fig. 14 P5000i Probe components
Quickcapture
TM
button
Instantly captures (and analyzes) fiber image
Focus Control
Latch lock
Barrel assembly
USB 2.0
connector
6 FT COIL Cable
Inspection tip
Magnification Control
Before using the P5000/P5000i scope, make sure the Bluetooth
option has not been activated, even once, after the start of the
MTS/ T-BERD 6000A V2. If it has been activated, stop and restart
the equipment before using the P5000/P5000i Scope.
To Next Page
Loading...
