Vicon Extra 532 - About the Machine; The Machines Field of Application; Correct Usage of the Machine; Incorrect Use of the Machine

Bleeding of the clutch.
Bleeding of the clutch
Bleeding of the clutch.
Bleeding of the clutch
Bleeding of the clutch.
Bleeding of the clutch.
The friction clutch is bled in the
following way:
• Open the guard and remove
the PTO shaft with the friction
clutch.
• Tighten all bolts on the friction
clutch.
• Fit and fasten the friction
clutch on the machine.
• Block the cutter bar by placing
a wooden block between the
two cutting discs.
• Start the tractor and connect
the tractor's PTO outlet.
• Let the friction clutch rotate
freely for approx. 5 seconds at
the lowest possible speed,
until it is warm to the touch.
Do not allow the friction clutch
to rotate for more than approx.
5 seconds at a time, as this
may damage the friction discs.
• Disconnect the PTO outlet
and stop the tractor.
• Remove the friction clutch
from the machine.
• Loosen all the bolts on the
friction clutch.
• Fit and fasten the friction
clutch on the machine.
• Remove the wooden block
from the cutter bar.
2.3 Bleeding of slip clutch
18