Safety
14
Connecting
Correct attachment of the machine
The machine must be correctly connected, following the instructions.
The machine can be detached from the tractor if the connection is not
carried out properly. Incorrect attachment can lead to accidents.
When attaching the machine to the tractor you must therefore:
• Make sure that the tractor cannot roll.
• Make sure that the tractor and the machine belong to the same
category.
• Never stand between the tractor and the machine during
attachment.
• Use the hydraulic three point suspension slowly and carefully.
Following the above instructions will protect you and others from
injury. Failure to follow the above instructions may result in serious
injuries.
Make electrical connection after attachment
When connecting the lighting equipment, the tractor must be stopped,
the ignition key removed, and all lights switched off. This will prevent
short circuits and damage to the electric circuit. There is a risk the
electric circuit can short circuit.
PTO shaft check
Refer to the manufacturer's user manual delivered with the PTO shaft.
It contains instructions on the correct use of the PTO shaft. Failure to
follow these instructions can lead to damage to the PTO shaft or the
machine.
To Next Page
