Cleaning
65
Cleaning
• High pressure cleaning equipment may be used to clean.
However, the area around the bearings should be cleaned using
gentle squirts of water.
• Hydraulic components should only be cleaned with gentle squirts
of water to protect the gaskets.
After cleaning
• Let the remaining water run off for about 1 hour.
• Remove any water which has collected behind the guards.
Use the correct cleaning agents
Use only PH neutral cleaning agents when cleaning the machine.
PH neutral cleaning agents give your machine maximum
protection. Cleaning agents with either a high or low PH value can
corrode plastic, rubber and varnished surfaces.
To Next Page
Loading...
