Safety
25
Maintenance
Comply with the service and maintenance intervals given in the
instructions
Comply with the intervals for service and maintenance as given in the
instructions. By complying with the maintenance intervals you ensure
that the machine will operate without malfunctions and provide
maximum protection for the environment. An incorrectly maintained
machine is a danger to the surroundings.
Maintenance of the PTO shaft
Comply with the prescribed intervals for servicing and maintenance of
the PTO shaft. Refer to the manufacturer's user manual delivered with
the PTO shaft. It contains instructions on the correct maintenance of
the PTO shaft. Failure to follow these instructions can lead to damage
to the PTO shaft or the machine.
Always use original spare parts on the machine
Always use original spare parts. Original spare parts should be used
for safety reasons. The manufacturer takes on no warranty responsi-
bility in cases where non-original spare parts are used.
Never perform servicing or maintenance work on the machine
when in motion
Servicing and maintenance work must not be performed on any part
of the machine when it is in motion. People or objects can be dragged
along or drawn into the machine, or may become trapped. Failure to
follow these instructions could lead to serious — potentially even fatal
— injuries.
High risk when performing service and maintenance work
When performing service or maintenance work there is a higher risk
of injury. Paying full attention to the above mentioned point ensures
your safety and that of others. Failure to pay attention to this point may
result in serious injuries.
Therefore, when you perform maintenance work:
• Disconnect the P.T.O shaft.
• Depressurise the hydraulic system.
• Stop or disconnect the tractor.
• Check that the machine is parked safely, support it if necessary.
• Do not use parts of the machine to climb onto it, the correct units
for climbing must be used.
• Make sure that the machine cannot overturn.
To Next Page
