Vigilant MX1-Au - Cabinet Installation

Document: LT0439 Vigilant MX1-Au Operator Manual
Issue 1.73 23 October 2018 Page 11-1
This chapter contains instructions for installing the MX1 and wiring it to
MX Loop devices, alarm devices, and ancillary equipment.
Further wiring and gear plate drawings are included in the MX1 Wiring
Diagrams Manual (LT0442) included with each MX1 panel.
Topic
See Page
Cabinet Installation
11-1
Wall Mounting – 8U / 15U Cabinet
11-2
External Wiring
11-4
Cable Entry
11-4
Mains Wiring
11-5
Mains Wiring – 8U / 15U Cabinet
11-5
Battery Wiring
11-6
MX1 Controller Wiring
11-7
MX Addressable Loop Wiring
11-8
AS 1668 Fan Control
11-10
Alarm Devices
11-11
Other MX1 Input and Output Wiring
11-18
Zone LED Displays
11-23
MX1 Networking
11-24
Initial Power On
11-32
Wiring must comply with AS/ACIF S009 and be installed
by an ACMA-registered installer.
Remove power to the MX1 panel before plugging in or
disconnecting modules such as 16 Zone LED Displays,
LCD/Keyboard, MX Loop Cards, etc.
MX1 is available in 8U and 15U cabinets that simplify installation by
provision of:
 appropriate mounting holes and mounting template
 space for cabling, including knockouts in the cabinet for top/bottom
cable entry and slots in the gearplate for entry from behind the
cabinet
Chapter 11
Mounting and Wiring Instructions
Introduction
In this Chapter
Cabinet Installation