Vigilant MX1-Au - Network Warning Status; Silencing Remote Alarm Devices

Document: LT0439 Vigilant MX1-Au Operator Manual
Issue 1.73 23 October 2018 Page 9-11
The <fault status> is one of the following:
Normal
There are no network faults present.
Fault
There are 1 or more network faults present.
The <points status> is one of the following:
Normal
There are no network faults present.
Fault
One or more network faults present.
Disabled
The point has been disabled.
Refer to the user manual for the specific remote device for further details.
The format of the Network Warning Status display is shown in Figure
9-12.
Fig 9-12 – Warning Status
The <warning status> is one of the following:
Normal
There are no network warnings present.
Fault
There are 1 or more warnings present.
The <points status> is one of the following:
Normal
The warning status is Normal.
Fault
One or more warnings are present.
Disabled
The point has been disabled.
Refer to the user manual for the specific remote device for further details.
On a networked system the MX1 panel may be configured to display
alarms from other panels on the network and to allow remote silencing
and disabling of the alarm devices at those panels. When an alarm is
received from one of those panels pressing the SILENCE/RESOUND
ALARM button on the local panel will cause the following menu to be
displayed:
Network Warning Status
Silencing Remote Alarm Devices
<point> <SID>
|
ENTER
PREV
Warning Status:<warning status>|
NEXT
<point status> |
DETAIL
<site name> |