Viking Access Systems E-4 - Magnetic Lock, Lock Solenoid

VIKING TECHNICAL SUPPORT 1.800.908.0884
31
Magnetic Lock, Lock Solenoid
NOTE:
Viking Access Systems does not provide external gate lock devices. These items can be
purchased from your dealer or distributor.
ACCESSORY CONNECTIONS
Power for the Locks:
Do not use the 24VDC power supplied by
the control board. An external power supply,
or plug-in transformer, must be used for
the magnetic lock or lock solenoid. Plug the
transformer into the “120VAC” receptacle
provided at the operators Power Box. This will
prevent rapid drainage of the battery in the
event of power failure.
The control boards “Magnetic Lock” relay is
rated for 10A-250VAC.
! TECHNICAL TIP: The Magnetic Lock Relay LED
will indicate status of the on-board relay
even if a lock is not connected to the control
board. Refer to page 34.
Aux.
Pwr
+ -
Magnetic Lock
N.O. N.C.
COM
Guard Station
GND
Close
Stop
Open
Loop Connector
GND
Center
GND
ReOpen
GND
UL
GND
+28V
Radio Station
GND GND
Radio
+28V +28V
Class 2
Supply +28V
Master
Slave
Siren
+
Limit Close
Limit Open
Slave
Limit Close
Limit Open
Master
Low Bat
Power
Radio
Rec.
UL
Sens
ReOpen
Sens
Center
Loop
OpenStopClose
Speed Overlap ODS
Timer
Sync
Auto Open
AC
AC
+
-
+
-
Bat
DC IN
Max Min
Normal
60
3
100060
Off
4A
15A
4
15
Aux.
Pwr
+ -
Magnetic Lock
N.O. N.C.
COM
Guard Station
GND
Close
Stop
Open
Loop Connector
GND
Center
GND
ReOpen
GND
UL
GND
+28V
Radio Station
GND GND
Radio
+28V +28V
Class 2
Supply +28V
Master
Slave
Siren
+
Limit Close
Limit Open
Slave
Limit Close
Limit Open
Master
Low Bat
Power
Radio
Rec.
UL
Sens
ReOpen
Sens
Center
Loop
OpenStopClose
Speed Overlap ODS
Timer
Sync
Auto Open Dual Gate
MS
AC
AC
+
-
+
-
Bat
DC IN
Max Min
Normal
60
3
100060
Off
4A
15A
4
15
Magnetic Lock
N.O.
N.C.
COM
Magnetic Lock
N.O.
N.C.
COM
Magnetic Lock
N.O.
N.C.
COM
Magnetic Lock
N.O.
N.C.
COM
Magnetic Lock
Lock Solenoid