Viking Access Systems E-4 - Table of Contents

VIKING TECHNICAL SUPPORT 1.800.908.0884
5
TABLE OF CONTENTS:
PARTS DIAGRAM/PARTS LIST 2
OPERATOR REFERENCES 3
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12
Important Safety Instructions 6
Important Installation Instructions 7
Maintenance 8
General Safety Precautions 8-9
Operator Classification 9
Secondary Entrapment Protection Requirements 10
Secondary Entrapment Protection Installation 11
Manual Release 11
Audible Alarm Reset Installation 12
Warning Placard Installation 12
IMPORTANT INSTALLATION INFORMATION 13
Specifications 13
GATE OPERATOR INSTALLATION 14-18
Pull to Open Installation 14
Push to Open Installation 15
Mounting the Gate Operator 16
Post Mounting Option 17
Limit Switch Setup 18
ECU BOX INSTALLATION 19
ELECTRICAL INSTALLATION 20-23
High Voltage Supply Option 20
Low Voltage Supply Option 21
Solar Supply Option 21
Motor Cable 22-23
CONTROL BOARD SETUP 24-26
Initial Settings 24-25
Obstruction Detection Sensor (ODS) 26
ACCESSORY CONNECTIONS 27-32
Radio Receiver (Typical) 27
Open Commands, Guard Station 28
Viking Loop Rack 29
Guidelines for Loop Installations 30
Magnetic Lock, Lock Solenoid 31
Barrier Arm Synchronization 32
TROUBLESHOOTING 34-36
LED References 34-35
Solutions 36
APPENDIX A & B 37-40
VIKING EXPANSION PRODUCTS 42
PARTS DIAGRAM/PARTS LIST
2
OPERATOR REFERENCES
3
IMPORTANT INSTALLATION INFORMATION
13
GATE OPERATOR INSTALLATION
14-18
ELECTRICAL INSTALLATION 20-23
CONTROL BOARD SETUP 24-26
ACCESSORY CONNECTIONS 27-32
TROUBLESHOOTING
34-36
VIKING EXPANSION PRODUCTS
42
APPENDIX A & B
37-40
CONTROL BOARD REFERENCES
4
IMPORTANT SAFETY INFORMATION
6-12
ECU BOX INSTALLATION
19