© 2010 Viking Preferred Service
44
Terminal Block
To access terminal block:
1. Remove main top/front and main top/rear
(see Main Top/Front and Main Top/Rear
Disassembly, page 39).
2. Terminal block is accessible.
3. Disconnect wires.
4. Remove screws securing terminal block.
5. Repair or replace terminal block as necessary.
6. Reverse procedure to reinstall.
Control Panel Disassembly
To access control panel:
1. Remove oven knobs.
2. Remove screws securing front trim and
remove trim.
3. Remove main top/front (see Main Top/Front
Disassembly, page 39).
Service Diagnostics and Procedures–Disassembly
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.
Terminal Block
Screw
Screw
Screw
Front Trim
Screw
To Next Page
Loading...
